Pathway eDIN LED Dimmer/DC Driver provides control over common anode LED fixtures and solid state relays.

1008 LED Dimmer/DC Driver

The eDIN #1008 provides direct pulse-width modulation (PWM) control of common anode, constant voltage LED fixtures—typically string lighting.  Multiple modes, including 16-bit, ensure a smooth dimming curve.  The module also provides efficient switching control of DC devices such as solid state relays and solenoids.

  • DMX512 start address and operating mode may be set from front panel interface or remotely using E1.20 RDM
  • Controls constant voltage LED fixtures rated between 5 to 30 VDC
  • Six PWM outputs, individually fused at 4A
  • 6A-fuse model available for use with 12V LED fixtures
  • Two spare fuses included
  • DMX512-present relay (normally open or normally closed)
  • Contact closure ‘panic’ input drives all outputs to full
  • Auxiliary 0-10V analog inputs HTP-merged with DMX input
  • Indicator LEDs for power, processor, DMX input, active output
  • User-adjustable smoothing algorithm
  • User-adjustable minimum and maximum output levels
  • Multiple loss-of-signal options
  •  Pluggable terminal block connections accept solid or stranded wire between #26 and #16 AWG
  • One DMX512-A/RDM data input connection
  • One passive DMX512-A data through connection
  • Data and power easily daisy-chained between modules
  • Termination switch
  • User-initiated diagnostics and test modes
  • Firmware field-upgradable using RDM (requires Pathway Pathport gateway and RDM utility program)
  • Default LED Control
  • DMX Double Precision with Curve
  • DMX Double Precision without Curve
  • Non-Dim Mode
  • Single Channel Control
  • Three Channel Mirror with Curve
  • Three Channel Mirror without Curve
  • 4A at 24VDC per output maximum (96W)
  • 1500V opto-isolation between input and output ports
  • 250V fault protection on input and output ports
  • Input operating voltage: 9-30 VDC
  • 5W power consumption
  • Operating conditions: 0-50°C; 10-90% relative humidity, non-condensing
  • ANSI E1.11 DMX512-A(2008)/USITT DMX512(1990)
  • ANSI E1.20 RDM(2010) - Remote Device Management
  • RoHS 2002/95/EC
  • Class 2 Low Voltage
  • 0.70 lbs (0.316 kg)
  • 3.6”W x 8.0”L x 1.5”H  (91mm x 200mm x 38mm)




eDIN Constant Voltage Dimmer/DC Driver, 4A fuse


eDIN Constant Voltage Dimmer/DC Driver with 6A fuse -
use with 12V fixtures



DIN-mountable 24VDC 30W power supply


Rack-mount Panel Kit (2RU) with
two 16.5” (420mm) sections of DIN rail


Small eDIN Enclosure (NEMA1) with
9.5” (240mm) of  vertical DIN rail


Large eDIN Enclosure (NEMA1) with
19.5” (495mm) of vertical DIN rail


Large eDIN Enclosure (NEMA1) with
three rows of 9.5” (240mm) horizontal DIN rail


eDIN Enclosure Assembly Service